Customer Reviews For The First Alert PC910V 10 Year Photoelectric Smoke & CO Alarm, Voice & Location
The Smoke & CO Alarms were easy to install. The installation would have been easier if the instructions were in a larger print font, too small for my 70 year old eyes.
Stylish design that takes up less space than individual units.
I recently purchased the First Alert Combo Smoke & CO Alarm. It seems to be as advertised. It was very easy to install. I just read and followed the instructions. This replaced a similar First Alert device. The old unit had a battery that had to be replaced on a regular basis. It was advertised to last for 5 years, which it did, almost to the day. This experience was why I purchased two of the new 10 year units, with a 10 year battery. I trust First Alert to provide great protection for the advertised life, based on my previous experience.
Like how it says to evacuate building in case of co gas.
I use to have a separate smoke alarm and CO alarm and sometimes I forget which batteries need to be changed first. Now I have both in one and a 10 year battery life so I don't need to worry anymore.
Great service, easy to install - set up and forget!
First one had clips missing on unit, returned. The second unit sporatic test, did not work , then I removed it and it worked. Directions on installing confusing. Im not sure about the quality at this time.
Great slim design. Helps to know where in the house the hazard is by the voice alert.
Other reasons include: It could be a different device or appliance such as a security system, monitor, carbon monoxide alarm, or other device which has a similar low battery or alert signal. Some of the same factors that cause unwanted alarms can cause intermittent alarms: dust and insects in the alarm or power interruptions in hardwired alarms. Improper wiring on AC or AC/DC smoke alarms. AC alarms will chirp every 5 seconds if the interconnect wire is grounded. The orange interconnect wire should NEVER be grounded; it should only be used to interconnect other smoke alarms or compatible devices.
- You may not be holding the test button down long enough. Try holding it down for up to 10 seconds (20 seconds on photoelectric models) .
- Your battery may not be installed properly or snapped all the way in place. Even if the alarm sounded briefly when the battery touched the terminals, you still need to make sure it is snapped securely in place. If the battery is loose, in cannot power the smoke alarm properly. After installing new batteries, be sure to test your smoke detector.
- Your AC power may not be on. AC and AC/DC units will have a power indicator light (red or green) that shines continuously when they are receiving electrical power.
- If you have a 10-Year model, the smoke alarm may not have been properly activated. If the tab broke away before the alarm was activated, you can use a toothpick to move the switch over to test the alarm.
- There may be insufficient battery power, try new batteries.
- Problems with voltage or insufficient electrical power (brown out) may cause a continuous weak sounding alarm. For AC or AC/DC models, temporarily disconnect power at the service panel until the brown out is over. If you do not restore the AC power, your smoke alarms cannot warn you of a fire.
- Incompatible warning device. If an incompatible alarm or auxiliary device is linked into a series of AC or AC/DC smoke alarms it may cause the system inadvertently go off.
- It is possible that your smoke alarm "silence" button was pushed by mistake. The alarm will now "chirp" once a minute for up to 15 minutes before resetting.
- Are you sure it's the smoke alarm? Funny to ask, but other devices have similar low battery chirps or warning tones.
- Your "new" batteries may not be fresh. If batteries are stored, especially in cold areas like refrigerators, they lose their charge more quickly. Always check the freshness date on the package when buying new batteries. Keep plenty of replacement batteries on hand so that you are sure to always be protected by your smoke alarms.
If it's time to replace your alarms, consider the NEW 10-Year Life series and never have to worry about a battery replacement for the life of the alarm.10-Year alarms are available in smoke, carbon monoxide and combination alarms.
Here are a few situations that may cause a carbon monoxide alarm "false alarm:"
- The carbon monoxide alarm needs to be relocated. Carbon monoxide alarms should be located 15-20 feet away from all fossil fuel burning sources like furnaces and stoves. Alarms should be located 10 feet away from sources of humidity like showers.
- Fossil fuel burning appliances may not be burning fuel completely. Check pilot lights/flames for blue color. Appearance of yellow or orange flames indicates incomplete combustion-a source of carbon monoxide.
10 Year Photoelectric Combo Smoke & CO Alarm w/ Voice & Location
Combining the individual strengths of the standalone versions of the Smoke Alarm and Carbon Monoxide Alarm in the Ten Year Series, the PC910V utilizes Photoelectric Nuisance Resistant Technology to effectively decipher between serious and minor levels in smoke detection. Combine this with an Electrochemical CO Sensor that sets an industry standard in identifying carbon monoxide and you have a combination alarm that excels on all fronts. The PC910V Smoke and Carbon Monoxide Alarm features an unprecedented ten year lifespan that complies with the Current 10-Year Legislation. A leap in technology has eliminated the need to ever power or charge this unit with batteries. The realization of a Voice and Location Feature combined with a fully powered LED and Alarm Indicator serve admirably in warning all nearby participants of smoke detection and a leak in CO.
Photoelectric Sensor Warns of Smoldering Fires
The First Alert PC910V Smoke and Carbon Monoxide Alarm comes equipped with a photoelectric sensor to provide the earliest possible warning of fire. The sensor is optimized to detect larger smoke particles produced by smoldering fires, such as those caused by unextinguished cigarettes. It also distinguishes between real threats and smoke/vapor produced during showering, cooking, and other everyday activities, helping minimize the number of false alarms. A patented smoke entry system helps ensures reliable detection by providing a direct air pathway to the sensor.
Electrochemical Sensor Monitors CO Levels
The alarm also features an advanced electrochemical sensor that detects carbon monoxide leaks from a variety of sources, such as faulty fuel-burning appliances, blocked chimneys, and cars left running in the garage. Carbon monoxide can't be seen, smelled, or tasted in the air, and it is the leading cause of accidental poisoning deaths in America. By placing carbon monoxide detectors on every floor of the home and in each sleeping room, you can help protect your family from the danger of carbon monoxide.
Talking Voice Alarm Tells You Where the Danger Is
The First Alert Smoke and Carbon Monoxide Alarm not only alerts you when smoke or carbon monoxide has been detected, but it also tells you where the danger is.
Modern, Sleek Design
Unlike older, bulkier detectors, the First Alert PC910V Smoke and Carbon Monoxide Alarm features a modern, thin design that can be unobtrusively mounted on a wall or ceiling. The sleek white finish coordinates seamlessly with most home decor.
Built-In 10-Year Battery
The First Alert PC910V Combination Photoelectric Smoke and Carbon Monoxide Alarm features a built-in 10-year lithium battery that provides continuous power for the life of the detector. An end-of-life timer lets you know when the device should be replaced.
First Alert 10 Year Battery Photoelectric Combo Smoke & Carbon Monoxide Alarm with Voice & Location can be preprogrammed with the following locations:
- Basement
- Kitchen
- Child's Bedroom
- Living Room
- Dining Room
- Master Bedroom
- Family Room
- No Location
- Guest Bedroom
- Office
- Hallway
- Utility Room
* Meets California, New York and New Jersey 10 Year Smoke Alarm Requirements
